SOUTHWEST RESEARCH INSTITUTE

Near Surface Geophysics Site Map

	A 2D profile of apparent resistivity generated from multiple 1-D TEM measurements using a 100-m loop was used along with magnetic readings to interpret the location of the fault illustrated in the profile.

Electromagnetic methods are used at Southwest Research Institute (SwRI) to measure subsurface electrical conductivity. SwRI scientists can perform electromagnetic surveys using frequency domain electromagnetic instruments or transient electromagnetic instruments.

Transient Electromagnetics

Transient electromagnetic (TEM) instruments allow greater depth of penetration of an induced current by using large transmitter loops and lower frequency signals.

TEM methods, also known as time-domain electromagnetics, measure the electrical conductivity of soil and rock by inducing pulsating currents in the ground with a transmitter coil and monitoring the decay of the induced current over time with a separate receiver coil.

Multiple one-dimensional soundings are used to generate two- and three-dimensional images of the subsurface. TEM measurements can be applied to:

• Delineation of the depth and thickness of geologic and hydrologic units

• Detection of the water table and water quality (salinity)

Advantages of Transient Electromagnetics

• Good lateral and vertical resolution

• Depth range of measurement approximately 20 to 3,000 ft

Limitations of Transient Electromagnetics

• Deep measurements require a large transmitter coil for which space may not be available

• Susceptible to interference from induced noise from power lines and nearby metal objects such as:

  • Pipes

  • Cables

  • Fences

  • Vehicles

For more information about our near surface geophysics and transient electromagnetics capabilities, or how you can contract with SwRI, please contact Ronald T. Green, Ph.D., at rgreen@swri.org or (210) 522-5305, or James Prikryl at jprikryl@swri.org or (210) 522-5667.

geophysics.swri.org

| Center for Nuclear Waste Regulatory Analyses | Geosciences and Engineering Division | SwRI Home |

Southwest Research Institute^® (SwRI^®), headquartered in San Antonio, Texas, is a multidisciplinary, independent, nonprofit, applied engineering and physical sciences research and development organization with 11 technical divisions.

August 18, 2011